UltiController Kit
€75.90 EUR ex. VAT was

UltiController Kit is unavailable

Leave your email address if you would like to be notified when it becomes available.


Print directly from an SD card

Included with every new Ultimaker Original purchase.

NOTE The UltiController is only compatible with the Ultimaker Original , Ultimaker 2 has an integrated control panel.

Delivery: 1-3 working days.

  • The UltiController works with the new Marlin firmware since Cura. You may only need to plug in the UltiController to get it to work. For older firmwares you should upload new firmware. You can do this directly from Cura.

Summary

The UltiController allows you to work with your Ultimaker in an entirely new way!

You can directly observe the effects of increasing the speed up to the optimal point where your print finishes nice and fast, and still comes out with good quality.

With the UltiControllers your 3D printer will be able to stand alone, so no need for having a computer attached! This is great, it allows you to put the machine aside and use your computer for something else. You're not forced to sit next to the Ultimaker, as addictive as it may be to watch it all the time. Also, it helps minimize the impact of a laptop battery going down, the occasional need for a reboot, etc.

The UltiController kit can be added to the existing electronics as of version 1.5. All of the units sold since March 2011 are backwards compatible. Also, the 1.5.6 version of the UltiController (shipping since February 2012) is automatically self-powered. For all Ultimaker electronics before the version 1.5.6, a small patch is required (a single wire) which will make the Ultimaker self-powering (otherwise you still need to power it over USB, requiring another USB-charger/outlet).

The UltiController will print your G-code files from a SD card..

The UltiController is developed by Bernhard Kubicek. The story of how it came to be, can be found here.

Features

  • Ultimaker Original electronics version 1.5 or higher