The Bowden tube, 67cm long. Made from PFA. Outside diameter 0.25 inches, inside 0.125 inches is used to transport the filament to the extruder head. Includes a Clamp Clip and...
The heater cartridge is being used to heat your hot end. Ultimaker 2 24V 25W
This is the Ultimaker 2 hot end isolator. It is the connection between the PTFE coupler and the nozzle + heater block. It is also included in the Ultimaker 2...
This is the Ultimaker 2 integrated nozzle + heater block for 3mm filament. This part is also included in the Ultimaker 2 hot end bundle. It has a 0.4mm diameter....
The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...
The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...
The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...
The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...
Summary This is the Heated Bed Assembly for the: Ultimaker 2 Ultimaker 2 Extended Ultimaker 2+ Ultimaker 2+ Extended This is the Ultimaker print table heated bed with cable. The...
The Ultimaker 2+ TFM coupler is an improved replacement for the PTFE couple and is suitable for the Ultimaker 2, Ultimaker 2 Extended, Ultimaker 2+, Ultimaker 2 Extended+ and the...
The Olsson Block is a new hot end for your Ultimaker 2. This upgrade makes it possible to very quickly and easily change nozzles on your printer. This makes it...